Integrated Sensor Faucet
Integrated Sensor Faucet Features
1.Control:Designed with SCM. Stop water automatically when water
flowing exceed 1 minute.
2.Adjustable distance: Induce distance can be adjusted free of
3.Strainer device: Strainer can be removed and clean to prevent
4.Check valve :Check valve inside the faucet body.
5.Structure: With warm ＆cold adjusted handle.
|Detailed Product Specification|
|Applicable Water Pressure||0.05-0.7MPa|
|Water supplying caliber||G1/2|
Instructions for use
1. Sensor/fiow test.
When the unit is powered on, water should flow immediately when you
put your hands within range of the sensor. When you remove your
hands out range the water should stop immediately.
The maximum duration of continuous flow is 1 minute.
2. Sensor range
The default factory set distance is 12~15 cm. When powered on for
the first time, place your hands at the desired distance within 5
seconds after the power has been switched on and remove your hands
after approx 2 seconds in order to change the factory setting.
To reset the setting, interrupt power for at least 30 seconds and
follow the procedure as described to set the sensor range
To prevent blockage please clean the strainer regularly, make sure
you shut of the water mains, unscrew the water inlet hose, remove
the strainer, clean with water and a soft brush. Then install the
items in reverse order, turn on water mains and check for leakage.
The indicator light in the sensor will flicker 3 times per second
to indicate the batteries are at the end of their useful life. At
this stage the unit will not operate in battery more anymore
In case you have plugged in the mains, disconnect power and open
the cover of the control box, open the battery holder, remove the
batteries and replace all batteries with new ones.
Please make sure you install the batteries in the right direction,
the + and – side are indicated in the battery holder.
Close the battery holder, place the cover back in place and tighten
Follow the instructions for setting the sensor range if required.
The unit does not work. Please check for power connection or
replace the batteries, check connection of the sensor cable.
There is power however no water flow,
Please check the water supply, open any closed valves if necessary
Check water connections for blockage, clean if necessary
Check Strainer for Blockage, clean if necessary
Disconnect power for 30 seconds and re install
Check water connections for twists
Check sensor cable connection
Clean the sensor with a soft cloth
Please handle the product with care whilst installing
Only clean with soft cloth, no abrasive cleaning agent, acidulous
Do not spray the control with water.
Only clean the sensor with a soft cloth, scratching will reduce the
range and sensitivity of the unit itself